Brass Heavy Duty Front Steering Knuckle for 1/10 RC Axial SCX10 II Honcho 90046 48g/pc

Axial scx10 2 Honcho. Install was easy and fitment was accurate. I noticed Improved performance right away. Use a little blue loctite on the screws.

Cumple su función

These knuckles came with all hardware necessary. The finish of the product was really good for the price. These are a direct replacement on SCX10.2. Different bearings are not needed as recommended above as the stock SCX10.2 bearings fit perfectly.

Installed ony scx10ii Everything fit good other than the inside axle bearing wouldn’t fit at all had to sand down a lot other than that it would of been 5 star

Perfect fit for the Axial SCX10 ii Honcho.*Note: All hardware is included but one screw was just a bit short. The original screw worked fine with the new knuckle.

This was an easy install. I used all of the original screws to install this. I didn't use any of the included screws.

Fit my 10ii RTR great. World of a difference in performance.

Bought this for an scx10ii, ar44 axle. One side looked pretty nice and it fit great, while the other had a horrible end mill finnish I immediately noticed ,and that would be okay, but no. Stupid ass bearing holes,( inner and outer) were not concentric to each other rendering them trash out of the box. The axle would not fit through the off-centered hole .Had me pretty mad. I had all my stuff apart and couldn't just fit the part and wasted my money and still need to find some heavy knuckles. I thought they'd be alright by the reviews but be aware !!! There's some poor attention to detail here. And also you will need to debur the crap out of them, their really sharp on all the edges.