DAN SPEED 2 Inch Male x Female NPT Ball Valve S304 Stainless Steel,Full Port Heavy Duty for Water, Oil, and Gas,1000WOG (2 inch)

Great ball valve. I used them on moister traps. They hold up well used the on a fleet of truck.

Nice 2" SS BALL Valve for the price. I'm using it on my 6.5 HP pump outletI would buy it again if needed.

Good product

Works well for my use.

Looks well made butt......this is National Pipe Thread which is tapered to seal as the threads bind into each other. I can twist the threads all the way to the bottom into 90 degree fitting by hand and could still wiggle it. NO WAY WILL THIS SEAL WATER or anything else. Yes I know to use thread tape or pipe dope on NPT pipe, but that is really only to lubricate threads so they will tighten better to seal. To be fair theDAN SPEED NPT 1-1/4" Female x Female 90 Degree Elbow,Threaded Pipe Fitting SS304 Stainless Steel (1-1/4 inch) that I ordered with this works like it should.

Everything was spot on with this valve. Needed a 2" stainless to help with the freezing temps in winter. Threads were perfect and fit my water tanks without issues. No leaks. I have since installed these on all my tanks, four total, and have a backup for my last remaining tank that has a pvc ball on it. For the price you can't beat it.

IT MAY NOT WORK UNDER HIGH PRESSURE AND WILL NOT TIGHTEN BUT BOTTOM OUT INSTEAD A UNION IS A MUST.

Valve itself is fine but stainless steel is not ideal for NPT threading. Going into malleable iron threads don't deform to give a good bite. Can tighten it with all you got, even with a cheater bar. But just a bump the other way it'll spin out freely. Had to be mindful where to hold the pipe wrench lining up the other tees and elbows. I ordered 3 of these, male and female taper was fine. Steel is just a poor material for NPT.