MOOG K7258 Suspension Stabilizer Bar Link for Dodge Grand Caravan

Solidly built with a grease zerk for ongoing lubrication. Installation on a 2015 Chrysler Town & County was straightforward. Install the links with the top grease zerk toward the front of the car (the label will be readable vs up side down if installed correctly). Clunking noise was gone after installation.

Way better quality than the cheap links that you cannot grease. These bars are definitely made to last a lot longer. I personally prefer to routinely grease movable parts in order to flush out contaminants and debri also refreshing the lubricant. The gusher bearings on these links allow you to keep things running smooth for a long time. Installation is also easier with the built in hex nut to back up the stud. This will also make it easier to replace someday if I ever need too vs fighting a torx that is just going to strip out. I sprayed these links with some rust proofing paint to help fight future corrosion but they looked like they already had some type of rust preventative coating already. If your like me and do the research you'll see Moog parts are the way to go. These parts went on my 2000 Chrysler Town and Country. I replaced basically all the front end suspension and steering parts. I also recommend Moog's complete strut assemblies. My van sits back up where it's supposed to and rides like a Cadillac again. Also used Moog sway bar bushings, ball joints, tie rod ends, and wheel bearings on this project. One recommendation, if you need to replace the control arm bushings buy the whole control arm assemblies with ball joints. I made the mistake of rebuilding the arms myself. What a PITA!!! Save yourself the headache and pay a little more for the assembly.

Good quality, greasable. Worth a little more money to get Moog.

exact fit, no issues

Great part alot thicker than OEM.Grease fittings came pre installed.Reason for 4 stars and not 5 is the sticker says grease firing must face up? There are 2 sticker should say make sure lower grease fitting faces rear of vehicle to avoid rubbing from cv axle when turning.I had to reinstall one side.The nut is a 18mm and the bolt is 11/16th on the new part.Installed on 04 Pacifica .

A quality replacement swar bar link. Replaced as part of my front struts replacement project.

N/a

These were installed on a 2006 Dodge Grand Caravan. I was getting the classic clunking noise from the front end of my wifes van. I replaced these along with the sway bar bushings.... no more clunking noise and it drives like a dream. Out of the box you can tell the build quality on these are much higher than the OEM units, thicker rod and ball joint and also has grease fittings. I use Moog parts for all suspension work on my family's vehicles. High quality and a fair price.

I have used MOOG products for many years. I like the quality and the reasonable price.

Items arrived on time and definitely appear to be much more robust than the Mopar originals (see pic). Easy to install. Came fully assembled prepacked with grease (only discovered this after trying to push more in). Eliminated the front-end noise I was seeing so it's a mission accomplished here!

Don't waste your time with cheap stuff! I tried and they failed in less than 8 months. These Moog ones are twice as thick as the cheap ones and greasable. These are the ones to buy. (Unless your selling it)

Installed properly. I'll give more of a rating in 100,000 km.

Heavy duty . Best for your buck