RMR-Replacement Rear Quarter Window Glass Trim Fits Right/Passenger Side Lexus 2004, 2005, 2006,2007, 2008, 2009 RX330, RX350, RX400 Made in (USA)

These fit exactly as the original but needed some TLC to install. The pins do fit into the holes where the original trim fit, but the original trim must of had another fitting as I had to take the advice of reviewers and the instructions to fill the holes with sealant adhesive and also liberally added adhesive sealant to the body and trim before installing. It has now been on for months and seems to be securely intact. So far. So good.

Used for Lexus RX330 2004. Easy to install. Everything needed is included. CLEAN and dry thoroughly the area prior to planned installation. Practice a few dry runs.Many videos show how. Retract an inch of adhesive tape covering towards the glass side. Someone stole the original window trim. Used this to replace stolen trim. These are side specific. Used as passenger side rear window trim. Looks like original. Bit expensive but worth it.

Parts came quickly and well packaged. Fit properly and are of good quality. A $65 fix to a $300-400 problem if taken to the dealer. Very pleased.

Received within the specified time stated. Had to read through the instructions a couple of times to make sure I installed it correctly. which I did. Everything worked out fine.Don't have a clue what happened to the one that was on there originally "oh well" Good Job. Thanks.

Just installed yesterday, easy to install and seem well made. The price is silly stupid high however. They should be no more than $25 each. But this company realizes the majority of the RX330 for three model years would need one if not both replaced as the originals were defective. Just ordered a second one for the other side yesterday.

Frame arrived on time. Price is pretty steep, but I had no alternative. Installed pretty easy, but I had to file about 1/8 inch from the end of the lower small part of the frame. After installation, every time I would open the rear door the rubber door molding kept pushing the tip end of the frame out of place. I suppose this is why the original frame got blown off. I cleaned the window surface with alcohol so the frame adhesive strip would have a clean installation. I also used black sealant adhesive in the places where the frame nipples insert into the window surface. So far the frame is still in place and looks nice. I would buy again.

Too expensive

Very GOOD packaging! Perfect fit!