GDSTIME Quiet 80mm Fan, 12V 3PIN 80mm x 80mm x 10mm Brushless DC Fan for CPU Coolers

Work well, runs quiet. Seem to hold up well as I've not had any fail after about a year.

Great airflow. The description didn’t say it came with nuts and bolts, so that was a pleasant surprise that saved me a trip. I have them running at full speed, and the noise is minimal; there’s a quiet hum, but I’m using it for a 3D printer, which is louder, so it’s not really a problem. If you want a completely silent fan, you’re gonna have to pay a little more.

I needed a very slim fan for my Hyte Revolt 3 top fan. This one works great it has a strong and quiet motor. It really pulls the hot air out well. The quality is typical for a fan. It comes with a grill, and installation is pretty easy; you can plug it into a 4pin cable. I consider this a great upgrade at a very minimal cost worth every dollar.

Works exactly as it should. It's fairly quiet, not as much so as a noctua, but it does great. Tach works, and I've cycle tested. I have a set currently cooling my stepper drivers for a Manta board.

I used it as a replacement fan for my computer backup power supply. I would purchase two as they last about two years then start making noise. They run quiet.

these are nice little 3 pin fans. I got them for a SFF build but unfortunately they didn't fit, however I have tested them because I will eventually find a project for them. For a small SFF case, these actually move a decent amount of air considering that they are not pwm and they just have 1 speed they are almost whisper quiet. For the amount of heat generated by my little system these would have been exceptional for removing that heat and encouraging airflow. They feel well balanced too, I didn't notice any abnormal vibration in them when running so that bodes well for longevity of the bearing. They were also pretty cheap so this is a win.

Fits, works great, not exactly the most quiet fan.

Nice and quiet and work great