BLIKA 50 Pack Cable Railing Swage Threaded Stud Tension End Fitting Terminal for 1/8" Deck Cable Railing, T316 Stainless Steel, Cable Railing Tensioner 1/8" for 2"x2" Wood/Metal Post

The media could not be loaded. Great product

Awesome. Worked great to make my cable railing.

I used these to create a cable railing system on a deck we have at our recreation property. I used 4x4 posts and discovered a few things along the way that would have been helpful to know prior to starting. I paired these end fittings with these protector sleeves (https://www.amazon.com/dp/B086TZH8CJ?psc=1&ref=ppx_yo2ov_dt_b_product_details). The protector sleeve instructions said to use a 1/4" bit to pre-drill the holes in the posts. I used a 1/4" bit for all the posts, even the terminal end ones. I would recommend using a 5/16" bit for pre-drilling the 4x4s for the terminal ends. I had to re-drill all my terminal end posts to get the locks through without fighting them. Overall this was a simple install that took about twice as long as I thought it would, but that's mostly because I had to pre-drill everything twice. If you're using 4x4 posts you will need extra long drill bits to pre-drill. Also make sure you measure the cable out well because you can't tighten the locks too far with 4x4 posts.

I got these for my upcoming deck project as I plan to use cable railing. These look really nice and I think they'll work well on the end posts.

The media could not be loaded. Decent hardware for the money. Just make sure you get a decent crimper.

High quality hardware, I’ve done several cable rails with these and they look great. You need the hydraulic crimper because the sleeve is too strong for pliers

2nd time using these I love them so much

Basic threaded swage connector- pretty simple- and these were some of the cheapest per piece I could find. Did two crimps with a hydraulic crimper and they held great under a fair amount of tension. Inside diameter was accurate for 1/8" cable and the threaded end was not undersized but threaded into 1/4-20 anchor points just fine. The little included wrench was helpful for tensioning (the small end at least). Would definitely buy again for a future project.