Genuine GM Valve Part# 13596856

Way better than the knockoff one's that I tried first. Snapped right in and seals fit tight against the body. Knockoffs didn't fit tight.

They showed up on time everything worked great. It rained heavy the next two days after that no more flooded floorboard thank God I have a 2010 Chevrolet Silverado Work truck extended cab I uploaded an image of the old ones the new ones were identical. The part number was different on the one that came off my truck, but it fit perfectly Sealed no more flooded floorboard

original OEM GM part, fit as described, recommend

If you've suddenly started noticing wet carpet in your '99 - '06 pickup truck, you likely have a broken seal on the top of the cab vent. You can take a long screwdriver and a rubber mallet and smack straight down on the center of the top of the vent between the cab and bed and it'll pop right out. The new one will install with just a click. I didn't rip out my interior to get at the old one like some have done. After installing this, my carpet dried up and cab venting is perfect.

This product is OEM. It's easy to install and indeed stopped the leak. These are the source of major leaks in GM trucks as is the door couplers between the door jambs and the truck chassis. The other major spot is less talked about is beween the windshield wipers under the hood that leads to the cabin air filter. Another place which is not a major source is the door jamb rubber weather seal. The water can travel down it into the door sill because of water surface tension. Replacing that and taking care of any rust on the flange it connects too fixes that problem.

Perfect fit for your gm pickup

I put together. Easy! Quality is great for the price.

East install - From the outside of the cab (on the top side of the vent), take a long screwdriver to press down on the top tab on the old part. (Use a rubber mallet if needed.) The old part will fall out and drop on the floor. Clean the old decomposing rubber off the cab around the perimeter of the hole. From the top, I used a wet soapy rag wrapped around a short & narrow piece of plywood. From the bottom of the vehicle, I was able to reach and clean the remaining gunk around the hole by hand. Then from the bottom of the vehicle, slide the new vent in place. The new vent only partially slipped into place. Going back to the top of the vehicle, a tap on the top of the vent with the screwdriver to help seat the new vent the rest of the way.

GM genuine part and fits great

as factory

اصلي لكن السعر مرتفع مقابل قطعه وحده ، السعر مناسب لقطعتين