BIGTREETECH ADXL345 V2.0 Accelerometer Board Klipp-er Input Shaping 3D Printer Hotend Parts Sensor Module Support USB Connection for Voron Stealthburner

This was quite easy to use after following a YouTube video. It performed its function as stated and I found it to be quite a good value for its price point.

The product quality is excellent. It’s specifically designed to connect to Nema 36 steppers. However there are lots of adapters on Thingiverse and other sites to connect it wherever. It’s accurate, but clumsy. The new ADXL345 and S2DW are much easier to install and setup. They are almost the same price, but newer versions have the Raspberry PI RP2040 built in, for a much better USB cable plug in experience.

I found BTT documentation on this to be poor at best. Was able to get it working with help from the community, but would not recommend. The standard ADXL345 per-soldered is a better buy in my opinion. In fact, I purchased two, and threw this in the box of things for another printer.

Used this with my btt pi and while it did work, it took hours to get it working because there are no instructions available from the manufacturer. I did email them and asked but they just referred me to the other models instructions, which of couse are not useful. My advice would be to spend an extra five dollars and get a USB version of adxl. If I could give this item 0 stars, I would.

Unit works, but after disconnecting will no longer see USB. Even reboot system, will not see USB. Have to hold reboot switch and insert cable to find USB again. Then I have to refresh device to work properly again. update: Had to use generic flash selection, go to Bigtree tech for newest instructions. Unit work perfectly now