JONSBO N2 White NAS ITX Case 5+1 Disk Bays Mini Aluminum Case, Built-in 12cm Fan, SFX Power Bite (L150mm Max.), Support 65mm CPU Cooler, Integrated Upper Cover Removable，White

Probably not necessary to give this NAS box another 5 star review, but I will. Great product. Good design. Good quality. I was migrating my NAS from a previous enclosure that kept overheating my drives with 3 fans. With the open top design, its nice to mount your ITX board, and route your cables however you like. Routing 5 SATA cables may require some thinking. Especially because most ITX motherboards don’t have 5 SATA ports. As luck would have it, I was already using a PCI-SATA card, and all my previous 90deg SATA cables worked perfectly for minimizing cable traffic, but more importantly avoiding interference zones with the rear fan and restricting airflow. All went together nicely. Couple lessons learned. Immediately replace the mesh intake and exhaust mesh plates with 120mm grills. That will increase airflow and reduce noise considerably. And, connect your fan to your motherboard so you can control it, and not have to run it at full speed. The fan cable is plenty long enough to reach your motherboard. There are several posts on replacing the fan with an exterior Noctua, even a 3D printed mod to minimize how far it sticks out. These are all good posts, but I thought I would first try the stock fan. As it turns out, running the fan at about 30% rpm yields ample cooling and is quieter than my CPU fan. No need to be quieter than your CPU fan. All-in-all. A Great Product!

Nicely thought out and good looking case. I build a brand new 12+ bay rackmount NAS, and transplanted the old NAS parts to this case to use elsewhere. The rubber screw/handle system is unusual but is a cheap way to make the drives swappable without increasing the size or cost of the unit. It's "convertible" into a 5+2; they used the same upper bar on both sides so there are two screw holes present on opposite side of the designated SSD mount too. With some squeezing I got a second SSD in there ok. The slim fan is sandwiched between two very restrictive grills. Not quite sure how to address this yet. Also, it would have been a lot better if there was some kind of temperature control for the fan. I'm going to see if my motherboard temperature readout is effective enough to manage the drive temperatures, and connect the fan to the motherboard instead of the built in fan header. Route all your cables first before you screw anything down. I had to remove the motherboard to re-cable and somehow stripped a standoff screw hole in the process.

Used this for a TrueNAS home install. Great case, easy to setup. If I ever need to go to the basement where the server equipment is, it looks great (lol).

Tight squeeze but great size. Quiet

The instructions could be a bit clearer on the case but if you are a moderately experienced builder this shouldn't be an issue. Its a bit of a tight run to get the sata cables up from the mobo to the drive plane but its workable. I would recommend NOT plugging the fan into the backplane because it will just spin at 100% all of the time, i would instead plug it into the mobo. Definitely recommend a bit longer SATA cables than normal.