Compressed Air Line2312

Very impressed with this kit. I watched this kit for a while and waited till it went on sale. Once it did I ordered it and put it in the corner of my shop. That’s was 2months ago. Finally got ready to install. So, I done some research and was looking into how I was gonna straighten it back out because I’m OCD and wanted it straight. I had a PVC conduit pipe that’s I.D. matched the O.D. of the pipe. I was gonna run it through that to straighten it. Well when I opened the kit it came with a roller straightener that mounts to a table and you run the pipe through. Works great. Gets it close then once I fastened it with the surface mounts the kit come with it satisfied my OCD. The mounts that came with my kit are much better than what the images showed. Plus, unless I over looked it the roller/straightener wasn’t shown to be part of the kit. Over all very satisfied with this product.

I have three smaller shop buildings and I bought this to plumb all of the shops to my air compressor. It is so nice to have air to all three shops! We had zero leaks when installed and it was realitively easy!

Used the 200 ft kit to line my garage during framing stage. Your best bet is to get a tubing straightener to achieve clean lines and straight runs. As others have mentioned the aluminum blocks leak badly. This is due to the threads being straight cut not NPT. You'll need lots of tape and pipe thread sealant. Expect a sink your plugs and fittings all the way to the hilt.

Funny how things work well when you know what you’re doing. Many bad reviews on Amazon are mostly user errors, This kit is high quality and easy to work with. Comes with all hardware and even a tool to cut the piping. Only things i used from my garage was high pressure/blue teflon tape and Oring lube for the fittings. I highly recommend this kit.

The aluminum end blocks are extremely difficult to get threads to seal. Especially the supplied block to hose fittings. I have read all instructions and tips that I could find. I have tried several types of plumbers tape and putty. I think the fitting threads in to far. Poor QA. Feels kind of loose? Bought 3 sets. Out of the six aluminum end blocks I have tried so far, 2 are just not going to work, the other 4 are sealed at the moment but I have no confidence they will stay that way.

Was relatively easy to install and working fine.

While the airline and compression fittings are great, the blocks for the ends are machined poorly and won't seal with Teflon tape or non hardening sealer.

Easy to work with. Compatible with other 3/4 fittings. Professional looking install. Could come with more mounting brackets. I ordered the 120ft kit. Very satisfied with this kit