Break-Away 0.1" 2x20-pin Strip Dual Male Header Compatible with Raspberry Pi Zero GPIO(Pack of 10)

I haven't had chance to sit down and install one on my Pi Zero yet, but they seem well constructed and all the pins arrived unbent. I can't imagine problems cropping up with something so simple but if they do I'll update.

I know that the primary device to use this in is a Raspberry Pi but these can be used in any electronic device that requires a "Pin-Header" to be installed. I have used these to install a chip inside my OG Xbox and use another to repair a logitech mouse. Just simply break off what pin set you need for the job. in the case of my Xbox it was 2x6 configuration. Again, highly recommended for electronics fixing to bridging board together to make it easier to remove them for next time.

I needed one 12 pin section so I have 11 uncut strips that I don't have a use for.

I now have 10 forty-pin terminal strips that I have no need for and that aren’t worth the cost to drive them to a return site. The order sat for almost a week before shipment and it arrived a day after I needed it. The five stars are for the quality of the product, not for the shipping As for the quality of the product, no complaints. Each of the 10 strips appears to have 40 pins, straight, unrusted, and of the correct length. Free to good home.

Good quality.

Exactly what I needed

Great for break away pinouts, easy adjustment for pin height, I use them for uart pins on various devices, easy to solder too, solid connections, will purchase again as needed. Thank you

Worked with my first efforts with solder paste and hot-air reflow. Good GPIO joints.