AIRPLATE T7, Quiet Cooling Fan System 30cm

Super, super, super media cabinet upgrade. My cabinet was running a little hot, having recently changed my amp. It was with my heart in my mouth that I cut into my faithful old pine cabinet; one hole for the fan unit, another for the controller. The kit comes with templates to simplify marking up prior to cutting (decent jigsaw recommended). Totally worth it. I have it in auto mode and since installation, the temperature inside the unit has been cooler and much more stable. The fan has several speeds, which can automatically adjust according to the variance from your target temperature. For me, the pair of fans is rarely running even at half speed and this is enough to keep the cabinet at a sensible temperature. The unit is fairly quiet, but that does depend on the speed at which the fans are running. We notice it a bit when the fans start up, but it's barely a whisper at the lower levels. Certainly not enough to impinge on whatever we may be listening to. I've had the fans in situ for around a month and the kit is doing the job well, including through our current heatwave! Thoroughly recommended.

I bought this fan to cool the air around my valve hi-fi amplifier. Even though it sits on an open shelf, heat was clearly building up, especially on the shelf above where another device sits. I built a simple wooden frame for the fans so that I could suspend them from the shelf above and drag the hot air from the valves out to the side of the equipment. At the back would be better, if you can. It wasn't practical in my case. Normally these fans would be mounted in a more solid cabinet. I just used 1 piece of 26mm by 17mm by 600mm cut for 2 sides and 2 widths to make a clamp over the shelf. Wood-stained the frame and used 4 metal angle brackets and some screws. The thermostat controller has a wired temperature sensor that can be placed wherever you want to test. I attached it to the shelf above with Blu-tak (the hi-fi owners friend) so it reads the temperature right above the valves. The controller is powered by the supplied transformer plug. This is a US product but I got in the UK with a UK 3-pin plug. The controller has a number of modes, including setting the fans to 3 different speeds all of the time, or what they call smart mode. This is what I use. I selected 35 degrees Celsius as the temperature I want it to try not go over. If the temperature gets to that, it will run the fans at full tilt. 2 degrees below that and the fans go to mid-power to keep the noise down, and 3 degrees below the fans spin up to low speed. Below that and the fans stop, which means there's no noise and no wasted power. The controller displays in Celsius or Fahrenheit, by the way. There is also a spare USB socket to run another single or pair of fans, which you can buy separately, and they will all be controlled from the one controller unit. I currently run a USB desk fan from this in order to push the air away on the other side. I also screwed the controller to a couple of short bits of wood (same as the frame, above) to make a stand, where again it might be built into a cabinet. In the cooler months the fans can keep the temperature at 35 degrees, but with a summer ambient temperature in the room of 28 degrees C it tops out nearer 40 degrees C. The controller does have an alarm if the temperature gets too high, I think it flashes the backlight of the display. I've not seen that happen. Normally the controller displays the actual temperature of the sensor and the threshold that has been set, in smart mode. There are only a couple of buttons on the front of the controller that you need to use to set up your preferred mode and temperature, after that it's hands-off. I'm very pleased with this unit. The finish and build quality appear good, and it should last me 30 years. It's an expandable system and the fans run pretty quietly.

TLDR: this is a lovely bit of kit, looks really top-notch, easy to fit, but it came with a US plug. --- I ordered this along with some nice metal vents to provide cooling for our media cabinet. It arrived quickly but unfortunately it had a US plug instead of a UK one, so I couldn't use it. The product page states it has a UK plug so this was frustrating. I contacted the seller and they sent a travel adapter which I was not happy with - the plug was sticking way out and the connection of 2-pin US plugs is not very secure, I was worried about it coming halfway out and something touching the metal contacts. In the end they told me to order a suitable UK power supply and they refunded me, so the problem is resolved but it took a few weeks. (FYI this one is perfect - "MEROM 6V 2A Universal Power Adapter Supply with 8 Tips Compatible with Omron Blood Pressure, Baby Monitor, Bush Wooden DAB, Sony XDR-S55 XDRS55") Now I finally have it working I'm very happy with it, it's sturdy and well made, it looks smart. If the fans are on high speed they are audible in a quiet room but not when you have the TV on (I supposed it depends how close you are to them). It's expandable too, if you need more cooling you can add extra fans (either daisy-chain to the existing fan, or plug into the second USB port on the controller). You could totally build something with similar functionality for less money, but the quality of finish you get with this and the convenience is well worth the money IMO.

I love it! I didn’t expect so much heat when I created my media cabinet. At first I bought a smaller fan from AC Infinity which was beautiful and worked well. However as the cabinet filled up it needed more cooling and this larger fan, with the controller, was ideal. This new set ‘daisy-chained’ with the smaller fan seamlessly. The fan is quiet enough, and is generally drowned out whenever any of the electrical gear is running anyway. It is simple enough to use, it’s easy to fit (helped by the stencil), very effective at cooling, and especially beautiful. What more could you want?! The only downside is the controller is too precise ie. there is no buffer when the controller hits the set temperature. So this means that it can go on and off several times a minute for only seconds at a time. It’s easily solved by reducing the temp to below what can be reached, or taking it off auto. The only thing stopping it being perfect for me.

I recently moved my desktop into a cupboard and, since I mainly use it for gaming, I was a bit worried about temperatures getting too high. I decided to invest in these cooling fans and couldn’t be happier! Other than having to cut a hole to fit them, installation was straightforward and they feel very good quality. The cupboard now sits comfortably at around 29°C while gaming, and thanks to the automated sensors, the fans ramp up automatically when the temperature starts to rise. All in all, superb - really happy with them!

This certainly looks the part. The lovely brushed aluminium plates look great on the side of the AV cabinet and was the one reason I chose this, along with wanting the convenience of thermostatic control to save plugging and unplugging a fan each time I needed it. Although not silent, even when running at its slowest, it is barely noticeable when watching a film etc. I have it set up to draw cooler air into the side of the cabinet, with a cheaper USB fan at the back to blow the heat away. The thermostat gives many options to control the fan speed and when it kicks in and, so far, have been very pleased with it. A bit of tweaking will, no doubt, satisfy further! Installation was pretty straightforward due to the plastic templates supplied for each of the panels. These made it easy to get them in the desired position. For some reason, mine was not supplied with the UK wall plug as described. I contacted the seller about it and they sent an adapter straight away, which arrived much quicker than the original order, although I have to say that the monstrosity that is the power adapter, plugged into a UK adapter, plugged into a power strip, is a behemoth to behold! Overall, I would recommend this. It is a bit pricey but I guess you get what you pay for as it does look great. Just be aware of the UK adapter issue mentioned!

I am really happy with this purchase. I bought to help with cooling AV equipment inside a cabinet and it does the job perfectly - i was specifically interested in the "smart" function where the fan will only come on when a target temperature is exceeded. The build quality is excellent and the ability to daisy chain fans via usb is also a great bonus. It would be even better if additional temperature probs were included or could be added to cater for different areas and also if the digital display dimmed. I would recommend this and the single fan versions to anyone looking for a simple solution for thier cooling.

Incredible bit of kit. Easy to fit and setup, linked them with a smaller intake to build a console cooling/media box that was enclosed and perfectly removes the heat

Sistema súper probado que funciona de manera autónoma para mantener a temperatura correcta los dispositivos electrónicos dentro de un sitio cerrado

Impeccable

This thing rocks! I needed something to cool my new home theater rack with a glass door. It is now much warmer inside the unit than the previous "monster" rack I had with open shelves. I looked quite a bit but kept finding all kinds of fans for computers. I needed one like this that didn't need me to wire anything and I could plug into the wall. An added bonus to me is the thermostat controller. I didn't do anything fancy. I just drove a couple of finishing nails into the back of the shelf above my receiver and hung the fan assembly on the nails. The package does come with nice plastic templates to cut precise holes for the fan assembly and the thermostat if you want to mount them in a totally enclosed cabinet. Mine has open shelves in the back, I just wanted to move some air. The USB cord between the fans and the thermostat is long enough that I could place the thermostat controller on the top shelf next to my Monster Power supply with some leftover. The power cord from the thermostat with the little brick or wall mushroom is long enough to make it to the wall outlet with no problem. I set the thermostat controller on the shelf and it looks fine. There is a temperature probe wire attached to it that I hung down the front of the shelves to measure the temperature inside the cabinet. The first time I used it while watching a movie, I was not satisfied with the amount of cooling. Reason, I had the fans blowing into the cabinet over the receiver. This was maybe cooling the receiver like I wanted but it was just blowing a lot of hot air up over the rest of the electronics stack. I pulled the fan housing off the nails, turned it around and hung it back on the nails in the opposite direction to exhaust the hot air off the receiver out the back of the cabinet. That did the trick. I was able to set the temperature down to 76 degrees (my choice for now) and it easily holds that temperature. The temperature probe by the way is hanging just above the receiver. I am confident that it is being cooled like I want now. I've watched 4 or 5 movies since installing this unit and it does not make any perceptible noise when my home theater is blasting away. It maintains the set temperature steady as a rock! I keep it running after I finish watching the movie to allow the unit to cool down after I shut everything down and the fans are very quiet. Then I just have to unplug it from the wall. I am very satisfied. This thing was easy to set up, cools adequately and is quiet. The thermostat controller does have 2 USB ports so that you can add up to two more fans if you need more cooling power. I have had no problems with this quality product. If I do decide I need another fan, I would not hesitate to order another one.

👍

Sehr gute Qualität von der Verpackung bis hin zu den Geräten. Bis jetzt laufen die Lüfter ausfallfrei und funktionell. Negativ: leicht erhöhter Geräuschpegel bei Lüfterlauf