Brake Bleeder- Lightning Fast and Hands-Free

My brakes have been spongy I bought the jk used 2016 ,I am a retired Gm technician I read all the jk forums the brakes are spongy the brake fluid is black .I bled many times the fluid was still black .I bought the air zapper and the first passenger side rear wheel the container had little specs of rubber ? The master cylinder i rings have contaminated the system replaced the master they said you need a scanner to auto bleed the abs .I bleed the system twice going around with the zapper and the brake pedal is 100% eaven though it says you must auto bleed with a Chrysler dealer scanner .I have always did a two person bleed but this time I had to try this the dealer scanner is very expensive the spong brakes was the rubber I ring tiny pieces holding the abs valves open but that little vacuum bleeder did it yes it’s slow but it worked I drained out my complete system with this it’s know over a year later my fluid is clear brakes are normal any tech knows a panic stop to activate the abs will bleed the abs unit two or three cycles always worked never seen this before . It works it’s easy . I went crazy trying to get the brakes correct was going to purchase the scanner but very expensive.

Works great for Motorcycles.

It worked great while it worked. Pump housing just disintegrated for no apparent reason. Never dropped and always stored in it's case.

used a few brake bleeders this one is an awesome and simple to use. worked perfect on my wilwood brake system. all i used quick and easy took only 30 min to bleed my system steady slow stream didn't use more than 16oz to bleed a newly installed complete brake system. worth the money

Worked great for about 15 seconds then stopped working pumping. Sounded like it was on, had zero suction.

Was concerned with the connections through the reservoir lid, but, bled out my brakes super fast and easy after changing both front calipers out.

It works. You will need to play with it a bit to get the method down. If you get air through the bleeder screw you must seal the threads or you are just wasting your time. Storage jar is weak and should be sturdier in case of accidental crush/knock/trip. It is flimsy and will not stand up to any accidental event. The black adaptor fitting for bleeder screw doesn't fit anything. Go to Ace Hardware and get a miniature spring clamp. Once brake fluid gets on the tubing you will need the clamp. Just keep in mind this is a slow process and you will be happy. This will do the job but plan twice the time you are thinking.

proformed as stated just wish it had a little more suction