3M Adhesion Promoter 111, Clear, 250 mL Bottle, Fast-Acting, Quick Drying | Isopropyl Alcohol Based Solution, Promotes Better Adhesion of 3M VHB Tapes

This stuff works!!!!!

It's like alcohol on steroids. I cleaned all the gloss, wax and dirt off the top of the travel trailer before I use the 3M tape to adhere solar panels.

I have a Tesla Y dual motor long distance. I have added all sorts of "enhancements" to offset the cheap design shortages - movable screen, splash guards, cockpit enhancements, top-of-steering stalk charger, rear LED lights for rear tow patch section and other rear lights (which has saved me from one rear-end collision due to bright attention-grabbing strobe effect I am sure - the guy behind me pulled into the left-turn lane beside me and we met eyes). I installed a set of the neoprene gaskets to reduce dirt penetration and noise but the attachment failed in many places. I ordered this product, and spent a lot of time using goof-off to remove every bit of old neoprene. I then used 99% ethyl alcohol to remove all residue of the goof-off.. I then liberally used this product to coat the metal of the Tesla where the new neoprene gaskets were to fit, and I went wider just in case. After several weeks I can confirm that the new neoprene is holding fast just as it should, thanks to this adherent. Many suppliers give little pledgets like alcohol swabs of this 3M solvent chemical - buying this is far better value if you are serious about making an install bulletproof. I recommend this product and would buy it again. Oh, and yes, the Tesla has been even more quiet as a result. Even if you don't have a T you would be good to use this to apply any neoprene gaskets in any vehicle, or doors of your house, or window gasketing of neoprene material.

Excellent product. I use it anytime I need to mount something. I wish I knew about this years ago. This bottle is a much better value than the single use wipes. I think this will out live me

I decided to give this a try even though rubbing alcohol does the trick just fine. It's difficult to tell if it works better, but it definitely works very well.

Great stuff I used it to attach some fender flares to my offroad rig, cleaned both surfaces (fender flare and body planes) sandwiching a 3M double adhesive tape and they're are glued there, not even mud, heavy rain or rocks have made flimsy. Definetly will use whenever working with double adhesive tape

For my purposes with EVA decking to gelcoat, 3m #94 primer was much better... If you can't tell from the datasheets which one you need, #94 is probably better if you are looking for a strong bond.this is probably more appropriate for sticking to painted surfaces

This is expensive, but it was one part of a two-part strategy to mount a shower soap dispenser. The red-backed 3M tape works much better if you pretreat the surfaces with this solvent. I highly recommend.