Low Pressure LPG Propane Gas Fireplace Fire Pit Flame Failure Safety Control Valve Kit with Igniter Assembly Fire Pit Igniter, Push Button Ignition Kit for Gas Grill, Heater, Fire Pit

My fire table didn't work after being in a flood so I replaced the parts with this set. The parts were super easy to install. It didn't take long to replace the parts. It works great now! I highly recommend.

Got this to replace parts on a fire table, worked perfectly.

I cut the igniter tips and bent it, as it was too long for my fire pit. Works great

In minutes I replaced the old unit and it works fine.

Muy confiable! Excelente todo!

Good quality and a very good price compared to others. I had an easy time installing except for the igniter. Mine was a single prong instead of the double prong which is shown. I tried to make it work, but it did not fit into the frame like my old one and would short out. I had to order a separate single prong. So it all worked out in the end, just had taken longer than expected.

This saved my fire pit. My dog chewed on the knob and igniter button. Replaced all part with everything in this kit and my fire pit works like new.

Tried to install this but this doesn't fit this model correctly. Tried to modify to fit but the knob to the gas line doesn't stay on so the fire won't stay lit. The spark posts are too long and won't fit in the area it is supposed to fit in. Since I installed it, I can't send it back for a refund so I am out the money and it still won't work.

Si me gusto mucho el producto solo que una válvula me salió defectuosa compré 6 y tampoco e podido lograr recibir la factura estoy tal vez por que las importe de Estados Unidos a MEXICO no lo sé

Bought this to replace a seized valve for a propane firepit we got with the house we bought. Almost everything fitted perfectly, the ignition rods being a bit too long was the only issue. But with a pair of 8" pliers, I just cut them the same length as the original, bent the side that's supposed to be bent and it worked perfectly!

Works as described. Better than the original. Fitted it in place with minor adjustments. If it turns off after ignition, hold the knob pushed in for few seconds to let the gas flow, then you can set it to one of the different flame level.

I was able to use the heat sensor from this kit as it bolted right in to my old valve and the unit was able to start with a butane lighter …. my unit had a mechanical Ignitor built into the handle and i could not get it going so then I used their battery starter and had to drill holes to make it work but I was able to achieve… lot’s of work but after 4 hours of drilling starts like a charm. So I have their valve left over not used as I could not find the right orifice… they should provide adapters for smaller gas lines...

Updated my firepit as it was broken. Easy fit. A little longer than my original but not an issue. Make sure to have the right minimum length as you cannot stretch it. Take a picture of the previous installation and duplicate it.