16 Ft (5m) 196 Inch Sliding sash Windows Doors Tape Pile Draught excluder Brush Seal Strip weatherstrip 5mm x 6mm (3/16 1/4 Inch, Gray)

Well made and fits perfectly! Stopped the draft from leaky weatherstripping effectively and was super easy to install.

This is a brush style thin strip insulation that fits the groove on the sides of the flap on a doggie door. It’s designed to slide in the groove from the top which is not possible unless you took the door apart. But it works if you have a pointed round tool like they show at the bottom of their description page. Once I dug out the old strip bit by bit, I was able to insert the new strip the same way but I had to also use a small head thin screwdriver and push on both sides of the strip to get it in there. The backing is stiff and helps hold it in, just be patient and push both sides in all the way to the finish. No glue is needed. It worked well and our flap is tight once again! No more leaks or flies.

This weatherstripping proved to be the exact replacement for the damaged OEM strip in my 12 year old wood patio slider door from Anderson. The backer strip was a perfect match for width despite the reported dimensions being slightly wider. And unlike most of the other alternatives, this one includes a draft-excluder plastic strip in the middle of the brush, just like the original on the door that it replaced. PERFECT. Installation was a little tricky. Once halfway inserted into the track, friction of the brush against the wall required alternately holding the strip motionless and moving the door onto it until fully installed.

I bought this to add weatherstripping to the cat door. Now, this doesn't come with adhesive. The ones that do are bad. This one is pretty solid. So i got this one, and the 3m double sided tape https://a.co/d/aMusGnu. I first straightened it and bent the corners with a heat gun. Have to go real easy as the bristles melt. I used a pedal with the heat gun to pulse it as i was going over the strip. Then i put the tape on the strip, holding it in the vise. Trimmed the excess tape and attached it to the door. So far so good. If it falls off i may glue it with glue. Everything has to be warm and dry for the tape to hold. Tape is pretty strong. The strip does shed bristles a little bit, but very minimal and mostly if you pull on them. So i did not put it on the bottom of the door where it would rub on the cat. Don't want microplastics on my cat. I also cauterized the cut ends with a lighter.

Perfect replacement for vinyl windows

This is very easy to install and it is as advertised.

6mm != 1/4" This stuff is of decent quality. But the 6mm x 6mm is a bit too shy of 1/4" and the strip doesn't fit well in grooves for 1/4" weatherstrip. It falls out easily and is hard to pinch to keep it from sliding around.

Standard type building commodity. Looks fine, works fine. As you get to the bottom of the roll, it might be more work to slide it into the track because the plastic has curling in it. You can use a heating gun to straighten it out if you have trouble.

I used the product to replace the existing draught excluder that was damaged. It was quite easy to install and works very well. The only down side was the price and the length wasn't long enough to do a complete patio door. So I had to buy two packs.

Muy bien

Fits as it should. Seems to be good quality

Not suitable for my purposes.. I needed one that slides in to a groove in the bottom of the UPVC door.. these are sticky and too high .. but could well be good elsewhy

Good product. Seals the windows well. Cuts down noise.