XRDS-RF 50W PL259 UHF Male Plug RF Dummy Load, 50 Ohm

Not quite perfect 50 ohms but close enough. SWR across most of the frequency range for extra class is 1.1 to 1. Reactants and inductance was pretty close to norm. It seems to work just fine. I would guess it's underrated in terms of power, that is you can hit it with more power than it is advertised for before it begins to get warm.

It's a dummy load. If you're reading this, you already know what it's for, and what it does. The price was right, and it does what it's supposed to do.

If you need a dummy load, this will work great. I'm confident in it's design.

Good dummy load... shows 1.05:1 SWR on 2m and GMRS... have not tried on 70cm or HF. DMM shows 50.76 ohms. Rated for 50 Watts, but it have put 85 Watts into it for a few seconds at a time with no issues.

Great construction and performs like it should. Easy to install and a necessary tool for HAMS that like to experiment.

It seems to work ok. But it’s 42 ohms.

Works great. Made of good material. Connection are good and work well. The price is good for what you get.

A real Time Saver in the shop that takes the guesswork out of the equation. Quality seems good and it performs as expected.

I used the dummy load to set right the mic gain in my transceiver and it performed well. A good product.

very nice solid construction, beautiful design, and more important the performances are higher than expected.. on the VSWR image, the pink vertical lines show amateur bands where i will use it.. edit, second purchase for a SWR of 2.0 !! used with a "T" adaptor for to have a SWR of 2.0 (25 ohms) and now able of to verify all the "SWR Meters".. my nanoVNA show a SWR of 2.1 (146 MHz) from the radio in/out connection: the path is a short cable + SWR meter + antenna cable + "T" adapter + 2 dummy loads 50 ohms 50w.. tested at 45w (VHF at 146 MHz), only one VHF/UHF SWR meter (a rare "150w analog" type available here) give a better reading (SRW = 2.0) than any other "Digital" ones (who give a SWR < 1.5).. and this "Analog" one have, at least, adjustments.. note.. when you purchase a new SWR meter, to verify it, do this test..

I've been testing my VHF HTs with this and haven't had a problem. I've yet to connect it to my little VHF amplifier but I don't expect anything out of the ordinary. This dummy load is pretty solid. The connector is nice, and I've been getting a 1.0 SWR on all my testing.

Good dummy load. 50 ohm bang on. Flat match. Well constructed. As with all electronics test before use. No problems at all would recommend.

I got this RF Dummy Load to work in my CB Radio which is very useful to do transmit tests without swr and without disturbing people on the channel. Great Product