Dremel 531-02 Stainless Steel Brushes (2 Pack), 1/2" Diameter

Didn't fall apart like the others.

These work great within their rated RPM range. I'm convinced that all the people complaining about it shedding the wire bristles are just running it beyond the rated RPM. A lot of Dremel-type tools don't allow you to control the speed and just run flat-out at 18k RPM, and at that speed these will NOT work. You have to keep the speed within it's rated range, and then they hold onto their bristles just fine.

I got these brushes to shine up the electrical connectors on my very old VW Beetle with my Dremel tool. These brushes work well for that as they are small and fit into tight spots. I used them on the lowest tool speed using light pressure because that’s all that is needed. The first brush is beginning to fray a little but I don’t mind. Not expecting them to last forever.

I've had a Dremel for over 20 years, and it's the most useful, and most used tool I own. Over the years have tried different grinding wheels, sanding drums, etc. and have found the cheapo bargain fittings to be very disappointing. Especially the wire brushes! The cheap ones tend to fall apart very quickly, shed nasty sharp wires at high speed into my clothing, and don't last long at all. So have gone back to original Dremel attachments. Yes, they are more expensive, but genuine Dremel attachments are more than worth it in the long run.

Worked very well in removing rust from small metal areas such as a metal plant base.

I go with Dremel brand for wire brushes as they've always lasted longer and don't throw wire like cheaper versions I've used.

Dremel quality at an affordable price.

I really would prefer thicker gauge wires. These don't really remove much material, and they end up bent back even with very careful and light use. The inevitable strays that fly away will get stuck in your skin, but not very deep (wear safety glasses), but since they're steel, they don't get sucked into the vacuum very well and often stay on the floor for an unsuspecting bare or sock footed person later. The knockoff brands are even worse as they throw far more pieces everywhere even at slow speeds, so this is still the best you're going to get, despite not being real good. I'd be much happier with a slightly stronger gauge of steel.

Used for cleaning up a cast aluminium house sign prior to repainting. Whatever you do, *do not* exceed the maximum stated rotational speed (15,000 rpm), unless you want steel wires in your eye.

ótimo produto.

安い中華製は回転速いとワイヤーがぬけまくりますがこちらの商品は大丈夫です。

Buena calidad y precio

True Dremel replacement part. Great quality. Bought these after reading poor reviews of bulk lots of Chinese generics where the steel bits would fly off and embed in your clothes. This was worth the cost for the quality and safety.