24V 6A Power Supply Adapter

This works well for my Bambu AMS 2 Pro.

I use this for charging a EasyLonger 96000aH battery pack. The battery pack, for fastest charging, requires 24v supply, and draws nearly 4 amps... for hours per charge. To avoid cooking your charger, always make sure your're pulling less than 80% of the max amp rating. Short burts above that are fine, this one is rated to handle 6 amps, but if you're expecting 100% duty cycle you should keep the load/draw under 5 amps. This charger works great. (If you have a battery bank like the EasyLonger 96000aH that outputs 24v or lower, you won't be able to charge it in the car/truck/RV unless you get a 12v to 24v step up converter. After looking everywhere, I'll tell you, the "EASYLONGER Car Adapter for CPAP, DC 12/24V Converter" is the best one out there, and its reasonably priced. Allows you to plug into a 12v or 24v cigarette lighter, and allows you to select the output voltage of the DC connector as 12v (up to 5 amp) or 24v (up to 3.5 amp)... and even has a 30W USB -c port, and a 18W USB-A port).

Works great so far. I have a home made Bluetooth speaker that is used to power off a Milwaukee M18 battery when it was mobile, then a car battery when I had a bigger cart for it, but now it's just on my workbench on the shelf so it can handle up to 48v seems like a sturdy well built power supply no excess noise when plugged in.

got this for my electric skateboard knowing the plug was not going to fit. swapped plugs and it charges my board perfectly. says 6amp but takes hours to charge it so I doubt its actually 6 amps.

WARNING: FIRE HAZARD! Do not buy this for a DVR. As soon as I connected it, the wires shorted out and caught fire. Not only does the product not work, but it completely fried my DVR's internal motherbord. This is a dangerous product that cost me a lot more money in damages than the cable itself. Stay away

We are testing this in a harsh condition to see if we could use this for future equipment. We put a very serous load and ran the full day. The picture shows a resistive load. As a reference, the plate where the resistor loads are bolted to is serving as a heat sink and I can tell you that the sheet of metal was untouchable due to the heat. However the power supply remained warm (not too hot). Works great. I dont recommend anyone doing this extensive test. But it works great

Seems to work for most electronics requiring 24VDC. I did have a problem with some PC's that were rebooting when using this power supply. I suspect the 24V isn't maintained very well, so if you have electronics sensitive to voltage drop then you will need something else. I do like the quick connect and field wireable terminals, makes it handy to switch components. Just wish it maintained voltage better.

It worked. Voltage is about right.

Lo compre para un amplificador de audio, funciona perfectamente, en mi caso lo conecte un modelo ZK-1002T y le entrega buena potencia con esos 144watts.

Solo duro 2 días y ya no funciono, lo utilice para una tira led de 5mts