120 Volt Electric Circular Saw Blade Sharpener with Diamond & Emory Wheels

My wife and I have remodeled 13 houses and I’ve gone through a lot of sawblades in the last 32 years but I’ve kept them all. I bought this to see if I could re-sharpen a lot of my old blades because they get so expensive. In the last two weeks, I have re-sharpened six 12 inch chopsaw blades, eight 10 inch tablesaw blades, and nine 7 1/4 inch Skil saw blades. I have probably saved $500 on blades by just re-sharpening all those blades that I never threw away. The directions are not the best but when you figure it out, this is an excellent sharpener if you use a lot of blades.

Was skeptical about this but it seems to sharpen the blades without issue. Have used it now to sharpen several blades just to see how well it would do. Surprised it was easy to set up and figure out how to use. Started out on an old blade from a dewalt 18V saw since it was 20 years old. Cut a piece of plywood first then removed the blade/Sharpened and re-installed. Actually cut better after. Probably not as good as a new factory saw would but for a sharpened blade it worked well. Second blade I sharpened was from an old black & Decker corded saw. Second blade same test first before sharpening and then following sharpening. was able to get the B&D Blade even sharper than the Dewalt blade. Looking forward to using on my chop saw and table saw when the blades start running down a bit to keep them cutting like new. Great option to buying expensive blades and not that hard to figure out how to use. Note: start with and old inexpensive blade to figure out how to use it first. then move on to the more expensive blades is the way to go I Think.

This sharpener works great, but blade holder is difficult to use and keep tight. With patience it's good. I have seen you tube videos where guys made their own blade holders and the machine worked excellently. Same as the old Harbor Freight model. Worth the money. It does work.

It takes a little getting used to. I sharpened several 10 " and 12 " blades. Some were fine finish and others were a more aggressive blade. Each set up was different and took patience and experience to set up correctly. Knobs to tighten and loosen adjustments would help a lot. Tooling provided does work. Bottom line is this machine can do the job and the end result is good to great. Excellent value!

It's an excellent idea and design, but the instructions don't tell you the important stuff and they used the wrong spring for the stop gauge. As per the photo, you'd have to use your allen wrench through the hole in the adjustment shaft to tighten it up or your adjustments will keep loosening up on you. Keep everything as tight as you can. Second, the spring for the stop lever is to short on one side and keeps popping off of the flap which makes it useless so I have to run into town tomorrow for a better spring with longer leads

Work good no complaints

This is not a prescision tool and there is not a provided instruction sheet with adiquate information.

Best tool i have ever brought