Walfront 1.8 inch SPI LCD Display Module for ST7735 128x160 51/AVR/STM32/ARM 8/16 bit

Got a bad one but getting replaced

It works unlike another slightly cheaper brand

I never could get the SPI working on an UNO or a Nano Every. It lit up just fine and showed a default brush stroke on screen SDA should be either called SDI or MOSI for an SPI screen and go to pin 11 on an Uno, (SDA is used for I2C communication) SCK pin should connect to your SCK (pin 13 on an Uno) A0 is referred to as DC in Adafruit's code. Don't use this screen if you are a beginner... Not sure if mine was defective, but I spent a few hours trying make it work and failed...

I've used this LCD screen in my FLIR camera DIY project. Very bright and colorful

Parfait

Utilisé comme thermostat avec Home Assistant, branché sur un esp32/esp8266 .control d'intensité pour la luminosité,

Not touch screen like it shows explicitly in its advertising

Screen has a hole in it. The packaging from the vendor and Amazon where not sufficient to prevent damages. The screen has a hole in it probably from the unit on top of it since the pins are sticking out of the foam and bag it was stored in. Sending it bad DOA. Does not work with ST7735 or ILI934 libraries. Tried many variations.

Like how is was packed