DAYUAN Ball Joint Press & U Joint Removal Tool Kit with 4x4 Adapters for Most 2WD and 4WD Cars and Light Trucks

Cheap but effective ! Used this tool to press out a ball joint from my W211 Merc E-Class ....... wouldnt budge with the tool alone, had to also use heat, but after that it popped right out ! New one pressed right in no problem !!mNot the best .... but not the worst !!! It works

Really good for the money! Don’t worry about the slack thread…..actually helps when holding a million things at once with 2 hands and trying to tighten! Used for bottom ball joint, but then also for pushing back a callipar piston! Can see it lasting years. Also helps to tighten and give it a tap with hammer and then tighten again!

Had everything needed to replace the ball joints on a Range Rover P38 (upper & lower). One of the cups was even the correct size to seat the driveshaft oil seal too.

I purchased this tool with slight scepticism about its ability to do the job of a garage hydraulic press for removal / installation on my 18 yr old original ball joints. Gladly I can report it stood up to the task , however my advice is to have a second pair of hands as it’s a bit of a balance act with the cups right at the start. It’s a substantial build and quite heavy but would recommend to save the garage costs.

This product paid for itself within an hour of owning it, i had 2 very stuck torsion bar bushes on the front of restoration project, this tool popped them bolt out with the right setup and with ease. I went on to remove a rather rusty 52 year old suspension part to find i had to cut the original ball joint off (leaving a very rusty, very stuck bit of metal in it), i spent 2 days heating, hitting and trying to get it out... what got it out was this tool and i wish i used it to start with, wound it on in a vice and a few tightens later - it popped out. this tool was well worth the money and a great addition to any workshop / garage.

Great quality and very strong.

Works great, smashed my thumb with the hammer trying to knock out the ball joints then bought this, should have bought this first popped them out and pressed the new ones in with such ease. Good quality for the price.

This worked just as it should! I'm no mechanic but this made removing the old ball joins and installing the new one a very easy job. I had more trouble removing old bolts than using this. It's a tool that I may not use again for many years but it saved me hundreds of pounds having the job done at a garage. Would definitely recommend. Good sturdy tool and case.

Eccezionale ottimo prodotto lo uso per molte estrazioni dalla boccola ai cuscinetti, molto robusto lo consiglio ai fai da te

DIYを楽しむ人であれば全然良い物だと思います ただ製品自体が頑丈で、かなり重いのでドリフト、ボックスを取り付けてセットするのに1人では苦労すると思います アームを万力などで固定すると楽かも知れません

Great..

Hat wunderbar an meinem Mercedes w211 Facelift geklappt

Works great